Pella 816G0101 Installation Instructions Manual

6, Pella 816G0101 3 SEALING AND FASTENING THE WINDOW (CONTINUED) POCKET REPLACEMENT Improper screw depth, screw head driven below the surface of frame. Proper screw depth, screw head flush with surface of frame. G. Finish driving all the installation screws through the wood frame jamb, ensuring the head of…

8, 6 FIXED SASH REMOVAL (CONTINUED) FIXED WINDOW REPLACEMENT E. Apply sill ashing tape. Cut a piece of ashing tape 12" longer than the opening width. Apply at the bottom of the opening as shown (2A). Do not allow the ashing tape to extend past the new window depth. No…

2, INTERIOR Flashing tape INTERIOR Flashing tape Pocket Replacement – Go to Step 1 SASH REMOVAL Fixed Window Replacement – Go to Step 6 FIXED SASH REMOVAL on page 7 POCKET REPLACEMENT: Note: Verify the opening and window dimensions prior to removing the existing window s…

11, FIXED WINDOW REPLACEMENT B. Apply a bead of high quality exterior grade sealant to the head and jambs. C. Optional: Place a bead of sealant where the sill adapter meets the sill. If sealant is placed on the sill leave at least 1” of sill adapter unsealed at each end. is sill allow for i…

12, EXTERIOR FINISH e exterior frame and sash are protected by aluminum cladding with our tough EnduraClad ® or EnduraClad Plus baked-on factory nish that needs no painting. Clean this surface with mild soap and water. Stubborn stains and deposits may be removed with mineral spirits…

4, 2 PREPARE THE OPENING (CONTINUED) POCKET REPLACEMENT D. Test t the window. e window should be approximately 1/2” smaller than the opening in both width and height. Measure the distance between the frame and the sloped sill, this will be the height to which to cut the sill adapter. Ch…