Perle 1700 User And System Administration Manual

100, V.11/X.21 Null-Modem Cable Configuration Figure D-13 V.11/X.21 Null-Modem Cable The connecting cable must be a shielded cable. Circuits which are paired (contain an (A) and (B) reference) should be connected to twisted pairs within the connecting cable. This cable is needed when…

3, Using This Manual This Installation and Applications Guide provides the basic information required to initially set-up and configure the P1730 & PRO Bridge/Router. This guide is organized into the following sections: “ Installation ” provides instructions for installing the P1730 &…

21, Applications 15 IP Routing An Ethernet IP router is used to intelligently route Internet Protocol (IP) traffic to another network. The networks may be connected across a WAN link (illustrated below) or two LANs connected to the same dual LAN P1730. Figure 2 -2 IP Networks Routed across a …

41, Applications 35 Quick Start Frame Relay Since the P1705 & P1730 auto-learns the frame relay configuration, only a couple of parameters need to be configured before the unit is fully operational as an IP router for frame relay. Upon initial start up, the P1705 & P1730 are pre-configured t…

32, Perle 1700 Applications 26 Multilink Operation Multilink operation defines the use of more than one link to connect between two PPP routers. The MultiLink Operation option of the remote site profile for a connection is enabled by default. When a Multilink connection is established, the Multilink (MP) op…

1, Perle 1700 Series Perle 1700 SeriesPerle 1700 Series Perle 1700 Series Bridge / Routers User And System Administration Guide Part number 5500071-14 © Copyright 2002 by Perle Systems Ltd. …