PERMASTEEL PG-50410S0LB Operation & User’s Manual

21, 18  GENERAL Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment or excessive pressure unknowingly being applied to the unit. Periodic…

5, PERMASTEEL PG-50410S0LB 2 WARNING READ THIS SECTION FIRST BEFORE INSTALLING THE GRILL  This grill is designed to use LP (Liquid Propane) gas only. Please use the grill with the regulator supplied by PermaSteel.  The installation of this appliance must conform with local codes or, in the absence o…

10, 7 ASSEMBLY INSTRUCTIONS STEP IV :  Use 2 pcs of 5/32"-32x3/8” screws to attach the tank baffle on the left side panel.  Use 2 pcs of 1/4"-20x1/2” screws to attach the 2 small tank holder brackets which fix tank holder on right side panel. Hook one end of tank strap to ta…

19, 16  CONNECT THE REGULATOR TO THE LP TANK VERY IMPORTANT: - THE REGULATOR SHALL NOT BE IN A LOCATION THAT WILL ATTAIN A TEMPERATURE ABOVE 140℉（60℃）. - THE REGULATOR SHALL INCORPORATE A PRESSURE RELIEF VALVE OR OVERPRESSURE DEVICE. - THE INLET OF THE PRESSURE REGULATOR SHALL BE…

18, 15 ONLY USE THE REGULATOR AND HOSE ASSEMBLY PROVIDED WITH THIS GRILL. REPLACEMENT PRESSURE REGULATORS AND HOSE ASSEMBLIES MUST BE THOSE SUPPLIED BY THE MANUFACTURER This is a LP (Liquefied Petroleum Gas) configured grill. Do not attempt to use a natural gas supply unless the gr…

12, 9 ASSEMBLY INSTRUCTIONS STEP VIII:  Take out left side shelf carton from firebox, remove packing materials.  Use two 1/4-20 x 1/2” screws to attach left side shelf from inside of firebox. Use one 1/4-20 x 1/2” screws to attach left side shelf from outside of firebox.  Use…