Pfaff tiptronic 6232 Instruction Manual

55, I I Insert the darning foot: Set the needle at its highest point and push the pin of the darning foot fully into the hole C of the sewing foot holder. When doing this. the guide fork G should position itself around the presser bar. The wire E must be behind the fixing screw F. Now tighten screw …

85, ‘ I I I prog I I j -- I prog I — I I ________________ I s,I_— a 1 10.3511 2 0 2-3 J Fne 1 1 a J 1 0.25 j 0 • 1 IGuiftandI I patch- I b (3 10.35-lI 2 - 2-3 foot b 0.25 - - ] 45 Jworkfootj Fringe foot With this special foot for loop embroidery you can produce fantastic effects in n…

58, Sewing on zippers There are various methods of sewing on zippers. For skirts we recommend the fully concealed zipper, for men’s and ladies’ trousers the semi-concealed zipper. Various zippers are available. We recommend using a metal zipper for strong fabrics such as denim. For all other ma…

27, Pfaff tiptronic 6232 / The sewing foot is raised or lowered with the presser bar litter (20). Close the hook cover (28) and pull the thread under the sewing foot to the left. Raise the sewing foot. Hold the needle thread and turn the hand wheel towards you until the needle is at the top again and the bobbin threa…

83, I I I1 progI I I ja.a*jIjl a G I 2.5 0 I o j 3-5 I Bias I I tape I b j G j 2.5 O - binder Bias-tape binder Binding with a bias tape is a simple way of lending fabric edges a smooth, neat appea rance. You will need: bias tape, 24 mm wide, unfolded. Remove the presser foot and the sewin…

49, Fancy elastic stitch The fancy elastic stitch is very useful for mate rials that require a flat seam, e.g. terry cloth. — Place the two fabric edges so that they overlap by about 2 cm and overstitch each edge with fancy elastic stitch. Pennant stitch (models 6152 and 6232) The p…