Hart Scientific 9105 Operation & User’s Manual

3, Table of Contents 1 Before You Start ............................1 1.1 Symbols Used .......................................1 1.2 Safety Information.....................................2 1.2.1 Warnings..................................................2 1.2.2 Cautions .................................…

28, 8 Controller Operation This chapter discusses in detail how to operate the dry-well temperature con - troller using the front control panel. Using the front panel key-switches and LED display the user may monitor the well temperature, set the temperature set-point in degrees C or F, monitor the heat…

45, Press “SET” to set the BAUD rate to the new value or “EXIT” to abort the op - eration and skip to the next parameter in the menu. 8.11.3.2 Sample Period The sample period is the next parameter in the serial interface parameter menu. The sample period is the time period in seco…

62, Hart Scientific 9105 13 Troubleshooting 13.1 Troubleshooting In the event that the dry-well appears to function abnormally, this section may help to find and solve the problem. Several possible problem condi - tions are described along with likely causes and solutions. If a problem arises, please read this section car…

33, 8.5.1 Hold Temperature Display When the hold feature is enabled you can easily switch the display between the normal temperature display and the hold temperature display by simply press - ing the “UP” or “DOWN” buttons. The hold temperature display shows the hold temperature on t…

27, 7.3 Setting the Temperature Section 8.3 explains in detail how to set the temperature set-point on the cali - brator using the front panel keys. The procedure is summarized here. (1) Press “SET” twice to access the set-point value. (2) Press “UP” or “DOWN” to change t…