Hasselblad 848 Operation & User’s Manual

8, 8 Mounting and Unmounting the Batch Feeder e procedures for both mounting and unmounting the Feeder to/from your scanner require that you use the soware-guided procedure, which ensures that the mechanical pars of the scanner and Feeder are correctly aligned for each step. Always…

16, Hasselblad 848 16 Scanning with the Batch Feeder Batch Scanning with 3f e Batch Feeder is intended as a tool for scanning large numbers of originals in a production environment. For this application, we strongly recommend the 3f workow for maximum eciency and exibility. e 3f image-le for…

11, 11 Grasp the Batch Feeder rmly with one hand while holding the batch-scan door open on the scanner with your other hand. Align the connector and pins on the back of the Feeder with the holes and con- nector inside the scanner. Gently press the Feeder down and in place, making sure tha…

7, 7 Preparing the Feeder for First Use or after Shipping Before you begin to use the Feeder, you must remove the two shipping screws that secure the magazine during shipping. ey are located near the bottom of the Feeder on the back side, as shown in Figure 2, below. On new Feeders, thes…

5, 5 When you switch on the scanner, the Feeder will position itself into its “home” position, if not already there. Do not touch the Feeder while the magazine is moving. Before servicing the scanner and/or Feeder, the power supply must be disconnected from the mains (unplugged). It is not s…