Heatmaster HMDGII Installation And Operating Instructions Manual

8, THERMOSTAT REMOTE CONTROL + Remove screen from front of heater. Place the remote control receiver on the floor of the heater, over next to the inside wall of the heater. Run the two wires from the receiver through the opening in the floor of the heater so they can be connected to the valve. ( NOTE…

10, Heatmaster HMDGII CLEANING AND MAINTENANCE INSTRUCTIONS ALWAYS REMEMBER: 1. Do not place any combustible material near the appliance. 2. Do not place any paper, trash or other material on the log set or in the heater. 3. Do not touch any part of the appliance when the unit is in operation. Your heater is designed to…

2, WARNING! When used without fresh air, heater may give off CARBON MONOXIDE, an odorless poisonous gas. This heater is equipped with a PILOT LIGHT SAFETY SYSTEM designed to turn off the heater if not enough fresh air is available. If heater shuts off, do not relight until you provide fresh ai…

4, 4 COMBUSTION AND VENTILATION PROVISIONS WARNING: This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ventilation air. Confined Space and Unconfined Space The National Fuel Gas Code, ANSI Z2…

14, A connection wiring diagram to aid in locating components. FIG. 13 A schematic wiring diagram of ladder form. FIG. 14 WARNING Electrical Grounding Instructions This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be pl…