HEIDENHAIN ND 522 - 2-2011 Operation & User’s Manual

42, 42 I Operating Instructions I - 3 Milling Specific Operations Enter nominal position value for corner point 3: Y = +50 mm, select tool radius compensation R + with R+/- soft key, and press until R+ is shown next to axis form. Press ENTER. Traverse the Y axis until the display value…

29, ND 522/523 29 I - 2 General Operations for ND 522/523 1/2 Hard key The 1/2 hard key is used to find the half-way (or midpoint) between two locations along a selected axis of a workpiece. This can be performed in either Incremental, or Absolute mode. Example: Finding the midpoin…

84, 84 II Technical Information II - 5 Measured Value Output II - 5 Measured Value Output Examples of character output at the data interface A PC can be used to retrieve values from ND 522/523. In all three examples, measured value output is started with Ctrl B (sent over USB interface). Ctrl …

60, 60 I Operating Instructions I - 4 Turning Specific Operations Setting Tool Offset using NOTE/SET Function The NOTE/SET function can be used to set a tool’s offset when a tool is under load, and the diameter of the workpiece is not known. The NOTE/SET function is useful when de…

62, HEIDENHAIN ND 522 - 2-2011 62 I Operating Instructions I - 4 Turning Specific Operations Enter the diameter of the workpiece at that point. Remember to ensure the ND 522/523 is in diameter display mode (Ø) to input a diameter value. Press the DOWN ARROW key to advance to the Z- axis. Touch the workpiece surf…

53, ND 522/523 53 I - 3 Milling Specific Operations Execution  Execute the milling operation by opening the incline milling form, and pressing the ENTER key. The screen switches to the incremental DRO view.  Initially, the DRO shows the current incremental moving distance fro…