SoundCraft DAKOTA 328 Setup Manual

15, SoundCraft DAKOTA 328 Spirit Digital 328 v2 14 The Dakota will commonly be used with a software sequencer/hard disk recorder to allow the simultaneous playback and recording of 8 individual tracks of audio, via the ADAT I/O. Here, the software application must be configured to access the Dakota ADAT I/O via the relevant …

2, Dakota Setup Guide 1 Contents 1 11 1 Connecting The System 2 2 22 2 Digital 328 Setup 4 3 33 3 Dakota Setup 7 4 44 4 Using The Dakota With The 328 14 Digital 328 v2 and Frontier Digital 328 v2 and FrontierDigital 328 v2 and Frontier Digital 328 v2 and Frontier Design Group Dakota Setup …

14, Dakota Setup Guide 13 If you wish to use the MIDI interface on the Dakota with the 328, ensure that the MIDI mode is enabled on the Dakota Control Panel. With the System page still open, in the ‘MIDI Mode’ section, select ‘2x2’: MIDI information can now be recorded and played …

10, Dakota Setup Guide 9 On the Dakota, the stereo device ‘S 1:2’ (S/PDIF format) can be sourced from any physical input. In this configuration, it must be set to source from the Dakota coaxial S/PDIF input. With the ‘S 1:2’ input set to ‘Coax’, the Dakota receives the S/PDI…

16, Dakota Setup Guide 15 Spirit by Soundcraft Harman International Industries Ltd., Cranborne House, Cranborne Road, Potters Bar, Herts EN6 3JN, England. Tel: +44 (0)1707 665000 Fax: +44 (0)1707 665461 http://www.spiritbysoundcraft.com e-mail: [email protected] …