SpectraLink MOG400 Install Manual

8, SpectraLink MOG400 SpectraLink Corporation Facility Preparation Link WTS – Link 150 M3 MCU 2.2 The Front Panel of the MCU The MCU’s front panel contains the connections to the telephone system, switches to control system administration, and status LEDs. 1. STEP Button: Selects a specific lin…

25, SpectraLink Corporation Facility Preparation Link WTS – Link 150 M3 MCU 5.3 Install Outdoor Base Stations Outdoor Base Stations are equipped with a protective enclosure, designed to be mounted to a wall or pole. After the enclosure is mounted, the Base Station is inserted in the encl…

26, SpectraLink Corporation Facility Preparation Link WTS – Link 150 M3 MCU 6. Sample Schedule for Installation This schedule assumes that the facility has been completely prepared for the installation and that all Base Station mounting follows SpectraLink standards. For larger i…

24, SpectraLink Corporation Facility Preparation Link WTS – Link 150 M3 MCU If the LED turns solid red, there should be an error message on the MCU’s STATUS LEDs. Refer to Link 150 M3 MCU: Installation and Operation for error code message information. 5.2 Mount Base Stati…

13, SpectraLink Corporation Facility Preparation Link WTS – Link 150 M3 MCU 4.2 Pull Cable Pull the cable from the MCU location (usually in the telephone equipment room) to the Base Station locations designated on the floor plans. If the cabling exits the building, consult …

3, SpectraLink Corporation Facility Preparation Link WTS – Link 150 M3 MCU WARNING: Changes or modifications to this equipment not approved by SpectraLink Corporation may cause this equipment to not comply with part 15 of the FCC rules and void the user’s authority to…