Standard Horizon CP180 Owner's Manual

32, Page 34 GPS Chart Plotters R 3.2 AUTOMATIC TIME The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC or Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct time, first you must figure out the offset and if it is daylight …

125, GPS Chart Plotters Page 127 R 19.2 OPTIONAL WAAS GPS RECEIVER SPECIFICATIONS This optional WAAS GPS Receiver is based on a ultimate GPS engine that delivers accuracy better than three meters by decoding the GPS correction signals from the satellite- based WAAS (Wide Area Augmentation System). The G…

104, Page 106 GPS Chart Plotters R Time : To start the simulator you can insert the time. Cursor Control : Enables (On)/disables (Off) the cursor control. Demo Mode : In Demo mode the GPS Chart Plotter automatically places a Destination point on the Chart page and simulates navigation to the po…

97, Standard Horizon CP180 GPS Chart Plotters Page 99 R Figure 12.6a - NMEA Display menu on CP300/CP300i 2. The CP300/CP300i can use step 1, and from the factory the right most Soft Key is programmed for direct access. Press this key two times to show the NMEA Display page. Move the ShuttlePoint knob to highlight …

35, GPS Chart Plotters Page 37 R Figure 3.5 - Language Selection menu on CP300 NOTE If the selected language is not available on cartographic data, English language is used. WARNING If you have accidentally selected a language and are unable to select a language that is understandable, perform the foll…