Star Micronics TSP1000 Series Operation & User’s Manual

15, – 11 – 4-3. Connecting the Optional AC Adapter Note: Before connecting/disconnecting the AC adapter, make sure that power to the printer and all the devices connected to the printer is turned off. Also make sure the power cable plug is disconnected from the AC outlet. (1) Connect the AC …

20, – 16 – POWER lamp On On Recovery Conditions Automatically recovered by loading a new paper roll, then closing the printer cover. Indicators show that the paper end is approaching, but the printer continues to print. Error Description Paper out error Paper near end ERROR lamp Flashes a…

25, – 21 – 7. Adjusting the Near-end Sensor Use the following procedure to adjust the near-end sensor so it is compatible with the size of roll paper you are using. 1 Open the printer cover. 2 Determine the diameter of the roll paper you are using and find the required setting in the table be…

26, – 22 – When using the paper roll with a core whose inside diameter (A): ø25.4, outside diameter (B):ø32 Level 1 Level 2 Level 3 Level 1 Level 2 Level 3 ø44 ø48 ø52 10 14 19 6912 Paper thick- ness ( µ m) 85 105 Remained paper length (Approx. m) Detected diameter (C) (Approx. mm) C C B A …

13, Star Micronics TSP1000 Series – 9 – 4-1-4. Connecting Ethernet Cable (1) Make sure the printer is turned off. (2)Affix the ferrite core onto the ethernet cable as shown in the illus- tration below. (3) Pass the fastener through the ferrite core. (4) Loop the fastener around the cable and lock it. Use scissors …