State Water Heaters GS675HRVIT Instruction Manual

21, 21 VENT PIPE PREPARATION 1. INITIAL PREPARATION A. Make sure the solvent cement you are planning to use is designed for the specic application you are attempting. B. Know the physical and chemical characteristics and limitations of the PVC and CPVC piping materials that you are abo…

5, 5 Thank You for purchasing this water heater. Properly installed and maintained, it should give you years of trouble free service. Abbreviations Found In This Instruction Manual: • ANSI - American National Standards Institute • NFPA - National Fire Protection Association • …

15, 15 SEDIMENT TRAPS (DRIP LEGS) A sediment trap (drip leg) should be installed as close to the inlet of the water heater as practical at the time of water heater installation. The sediment trap should be either a tee tting with a capped nipple in the bottom outlet or other device …

17, 17 NOTE: This unit can be vented using only the following materials: PVC (Cellular Core; ASTM-F891), PVC (DWV; ASTM D2665 or CSA B181.2), PVC (Sch 40, 80, 120; ASTM D1785 or CSA B137.3), PVC (SDR Series; ASTM-D2241 or CSA B137.3), CPVC (CPVC 41; ASTM-D2846…

28, State Water Heaters GS675HRVIT 28 LEAKAGE CHECKPOINTS Never use this water heater unless it is completely lled with water. To prevent damage to the tank, the tank must be lled with water. Water must ow from the hot water faucet before turning “ON” gas to the water heater. A *Condensation may be s…