Sub-Zero 427G Installation Manual

3, Wine Storage 3 subzero.com Sub-Zero Wine Storage T he importance of the installation of the Sub-Zero wine storage unit cannot be overemphasized. Installation should be done by a qualified installer. Before you begin the installation process, it is recom- mended that you read this en…

15, Hinge Adjustment IMPORTANT NOTE: T he wine storage unit must be installed and leveled before door hinge adjustments can be made. The top and bottom cabinet hinges on models 424G and 424FSG are held in place with three permanent adjust- ment screws and two shipping screws. Refer to the illus- tration…

29, Models 427G and 427RG Installation 29 subzero.com OPTIONAL 90° DOOR STOP The door of models 427G and 427RG opens to 105°. A 90° door stop is built into the hinge system for installa- tions where the door opening must be limited. To engage the door stop, use the blade edge of a …

49, Model WS-30 Installation 49 subzero.com Flush Inset Panels R emove the grille panel assembly as described on page 39. Remove the top two corner screws and pull away the top frame. Slide the panel into position in the grille frame. If you are using a grille panel 1 /4" (6) or thinner…

11, Level the Unit U sing an adjustable wrench or pliers, turn each of the four leveling legs clockwise to raise the unit and counterclock- wise to lower the unit. Refer to the illustration below for location of the leveling legs. For model 424G, the countertop bracket should be used to make a…

24, Sub-Zero 427G Models 427G and 427RG Installation 24 Wiring Connections B efore the kickplate/grille is installed, all necessary wiring connections in the compressor compartment should be completed. If the dual installation heater kit is used with model 427G or 427RG, the power supply leads should be conn…