Subaru 2004 Legacy Service Manual

45, ME(H4SO 2.0)-84 MECHANICAL Engine Trouble in General 4) Engine stalls after initial combustion. Engine control system <Ref. to EN(H4SO 2.0)(diag)-2, Basic Diagnostic Procedure.> A Intake system Loosened or cracked intake duct B Loosened or cracked PCV hose C Loosened or cracked va…

5, ME(H4SO 2.0)-44 MECHANICAL Timing Belt 7) Remove the belt idler No. 2. 8) Remove the timing belt. 2. BELT IDLER AND AUTOMATIC BELT TENSION ADJUSTER ASSEMBLY 1) Remove the belt idler (No. 1). 2) Remove the automatic belt tension adjuster as- sembly. B: INSTALLATION 1. AUTOMATIC BELT…

38, ME(H4SO 2.0)-77 MECHANICAL Cylinder Block Standard diameter: 2.0 L model A: 92.005 — 92.015 mm (3.6222 — 3.6226 in) B: 91.995 — 92.005 mm (3.6218 — 3.6222 in) 2.5 L model A: 99.505 — 99.515 mm (3.9175 — 3.9179 in) B: 99.495 — 99.505 mm (3.9171 — 3.9175 in) 2) How to me…

6, Subaru 2004 Legacy ME(H4SO 2.0)-45 MECHANICAL Timing Belt 2) Install the automatic belt tension adjuster as- sembly. Tightening torque: 39 N ⋅ m (4.0 kgf-m, 28.9 ft-lb) 3) Install the belt idler (No. 1). Tightening torque: 39 N ⋅ m (4.0 kgf-m, 28.9 ft-lb) 2. TIMING BELT 1) Prepare for installation of automatic …

35, ME(H4SO 2.0)-74 MECHANICAL Cylinder Block Tightening torque: First: 12 N ⋅ m (1.2 kgf-m, 8.7 ft-lb) Second: 12 N ⋅ m (1.2 kgf-m, 8.7 ft-lb) CAUTION: • Be sure to use a new gasket. • When installing the water pump, tighten bolts in two stages in alphabetical sequence as shown in the …

33, ME(H4SO 2.0)-72 MECHANICAL Cylinder Block (7) Place the cylinder block to face the #3 and #4 cylinder side upward. Following the same procedures as used for #1 and #2 cylinders, in- stall the pistons and piston pins. 20) Install the water pipe. 21) Install the baffle plate. Tightening tor…