Subaru H001SAJ200 Installation Instructions Manual

1, PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 1 Item Description Qty. 1 12V adapter plug, RA,13” L 1 2 Well Nut, Rubber, M5 4 3 Harness hold-down clip 1 4 Screw, SS, Phillips, M5, 20mm L 4 5 Fo…

2, PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 2 1. Turn car ignition to the off position until requested to turn on in step 10. 2. On the driver’s side rear quarter-panel interior trim, place and tape the provided templat…

3, Subaru H001SAJ200 PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 3 4. Align docking station over all four well nuts, then hand-tighten all four M5 screws with Phillips screwdriver, # 2. (Please note the dock bottom must clear the plastic rear cargo tray.) …

4, PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 4 7. With the antenna swivel point facing towards you, move the antenna slightly at an angle as shown. Align router over docking station and seat into dock (unit should snap in smoothly). Route and…

5, PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 5 10. Turn key to the ON position and observe blue led status. Status LED (Blue) Indicates Start-up Blue LED is off for approximately 15-20 seconds Initialization Blue LED is i…

6, PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 6 Print template at 1:1, do not scale. Confirm measurements of mounting holes after printing. …