Subaru Impreza 2004 Service Manual

17, BR-16 BRAKE General Description • RHD MODEL (A) Model without ABS (B) Model with ABS (C) Model with ABS (With hill holder) (1) Front brake pipe assembly (7) ABS control module and hydraulic control unit (ABSCM&H/U) Tightening torque: N·m (kgf-m, ft-lb) (2) Proportioning valve …

31, Subaru Impreza 2004 BR-30 BRAKE Front Disc Rotor If the disc rotor runout is above specified value, re- place the disc rotor. Disc rotor runout limit: 0.075 mm (0.0030 in) 4) Set a micrometer 10 mm (0.39 in) inward of the rotor outer perimeter, and then measure the disc rotor thickness. If the thickness of disc…

20, BR-19 BRAKE General Description 8. BRAKE PEDAL • 1.6 L MODEL (A) LHD (B) RHD (1) Stopper (10) Clutch pedal Tightening torque: N·m (kgf-m, ft-lb) (2) Bushing (11) Clutch cable T1: 5.9 (0.6, 4.3) (3) Pedal bracket (12) Clutch cable clamp T2: 8 (0.8, 5.8) (4) Snap pin (13) Clip T3: 1…

69, BR-68 BRAKE Brake Pedal 18.Brake Pedal A: REMOVAL 1. LHD 1.6 L MT MODEL 1) Disconnect the ground cable from battery. 2) Disconnect the clutch cable from release lever. 3) Remove the instrument panel lower cover from instrument panel. 4) Disconnect the connectors (for stop light switch, etc.) fr…

33, BR-32 BRAKE Front Disc Brake Assembly 4) Remove the brake pads from caliper body. <Ref. to BR-26, 17 INCH TYPE, REMOVAL, Front Brake Pad.>. 5) Remove the union bolt and brake hose from cal- iper body assembly. 6) Remove two installation bolts from housing. 7) Clean mud and foreign p…

42, BR-41 BRAKE Rear Disc Rotor 4) Set a micrometer 10 mm (0.39 in) inward of the rotor outer perimeter, and then measure the disc rotor thickness. If the thickness of disc rotor is out- side the service limit, replace the disc rotor. Standard value Service limit Disc outer dia. Disc …