Hornet 725T Installation Manual

17, © 2002 Directed Electronics, Inc. Vista, CA 17 on-board stinger doubleguard shock sensor There is a dual-stage shock sensor inside the control unit. Adjustments are made via the rotary control as indi- cated in the diagram. Since the shock sensor does not work well when mounted firmly to met…

4, 4 © 2002 Directed Electronics, Inc. Vista, CA installation points to remember Do not disconnect the battery if the vehicle has an anti-theft-coded radio. If equipped with an air bag, avoid disconnecting the battery if possible. Many airbag systems will display a diagnostic code through their warn…

2, 2 © 2002 Directed Electronics, Inc. Vista, CA Bitwriter™, Code Hopping™, DEI®, Doubleguard®, ESP™, FailSafe®, Ghost Switch™, Learn Routine™, Nite-Lite®, Nuisance Prevention Circuitry®, NPC®, Revenger®, Silent Mode™, Soft Chirp®, Stinger®, Valet®, Vehicle Recovery Sy…

21, © 2002 Directed Electronics, Inc. Vista, CA 21 In order for this system to control one or more after-market actuators, a Directed 451M or two relays (optional) are needed. Vehicles without factory power door locks require the installation of one actuator per door. This requires mou…

5, © 2002 Directed Electronics, Inc. Vista, CA 5 Some good siren locations: Some things to remember about where to mount the control module: ■ Never put the control module in the engine compartment! ■ The first step in hot-wiring a vehicle is removing the driver's side under-dash panel to…