Horstmann ChannelPlus H47XL Series 2 User Operating Instructions Manual

9, Horstmann ChannelPlus H47XL Series 2 9 Adjusting Time and Date The ChannelPlus H47XL Series 2 programmer has been set with the current time and date during manufacture. No alteration should be required to the time and date, however if any modication is required please refer to the owchart below. PLEASE NOTE: Any a…

10, 10 Adjusting Clock Options The programmer has been preset to display the time in 24 hour clock format, should you prefer AM/PM format then please use the procedure given in the owchart opposite. General Information BATTERY The programmer is tted with a non-rechargeable, non-serviceable …

8, HTG1 Auto Off until 18.30 HTG2 Auto Off until 18.30 HTG3 Auto Off until 18.30 WATER Auto Off until 18.30 8 Adjusting Default Settings The ChannelPlus H47XL Series 2 has a number of default settings which are normally installed. These settings are designed to reduce the need for user intervention …

6, 6 Setting the Programme Times The programme times have been preset as shown in the chart below. If any changes are required to the programme times please complete the operation as described in the owchart left. 1st ON 1st OFF 2nd ON 2nd OFF 3rd ON 3rd OFF Mon - Fri 6.30AM 8.30AM …

3, Display Information The ChannelPlus H47XL Series 2 programmer has a fully graphical, back- lit display. In the normal run mode the display is divided into 4 sections, each section represents a controlled channel. The information displayed will change depending upon the settings made …