Hoshizaki KML-200MAE Service Manual

39, 39 7. REMOVAL AND REPLACEMENT OF EVAPORATOR IMPORTANT Always install a new Drier every time the sealed refrigeration system is opened. Do not replace the Drier until after all other repairs or replacement have been made. 1) Turn off the power supply. 2) Remove the panels and the Top Insulatio…

12, 12 IMPORTANT 1. Board never accepts defrost completion signal within the first 2 minutes in defrost cycle. 2. Defrost cycle time is limited to 20 minutes even if Defrost Timer does not stop counting. 1. Unit energized and Control Switch to “ICE” position. Water supply cycle …

25, 25 To Freeze Cycle To Stand-by Cycle (When Control Sw. is turned OFF, Pressure Sw. is OFF, or Thermistor Temp. exceeds t1.) From Freeze Cycle Control Sw. in WASH Max. 20 min *1 The Pump Motor waits for 2 seconds before starting a drain cycle. See “II. 2. [d] CONTROLS AND ADJUST…

49, Hoshizaki KML-200MAE 49 11) Replace the Insulation Panel and the Front Panel in their correct positions. 12) Turn on the power supply and start the washing process. 13) Turn off the power supply after 30 minutes. 14) Remove the Front Panel. 15) Move the Service Switch to the “DRAIN” position. 16) Replace th…

27, 27 [b] KML-200MWE HEAT OF REJECTION FROM CONDENSER 5650 W [AT 90°F (32°C) / WT 70°F (21°C)] HEAT OF REJECTION FROM COMPRESSOR 381 W [AT 90°F (32°C) / WT 70°F (21°C)] WATER FLOW FOR CONDENSER 67 gal./h (17.7 lt./h) [AT 100°F (38°C) / WT 90°F (32°C)] PRESSURE DROP OF CO…

34, 34 2. BRAZING WARNING 1. Refrigerant R22 itself is not flammable, explosive or poisonous. How- ever, when exposed to an open flame, R22 creates Phosgene gas, hazardous in large amounts. 2. Always recover the refrigerant and store it in an approved container. Do not discharge the refrigerant into…