Hoshizaki Serenity Series KMS-2000MLH Instruction Manual

10, 10 2. SRK-20H/3 Unit: mm [in.] Note: Legs are included with condensing unit. Leg height is 380 mm (14.96 in.). …

27, 27 G. Water Supply and Drain Connections See Fig. 17 WARNING Water supply and drain connections must be installed in accordance with applicable national, state, and local regulations. NOTICE • Normal operating water temperature should be within 45°F to 90°F (7°C to 32°C). Operation of …

7, Hoshizaki Serenity Series KMS-2000MLH 7 2. SRK-20H The nameplate provides electrical and refrigerant data. The nameplate is located on the condensing unit. We reserve the right to make changes in specications and design without prior notice. MODEL NUMBER SRK-20H SERIAL NUMBER AC SUPPLY VOLTAGE 208-230/60/1 (…

32, 32 III. Cleaning and Maintenance This icemaker must be cleaned and maintained in accordance with the instruction manual and labels provided with the icemaker. Consult with your local Hoshizaki Certied Service Representative about cleaning and maintenance service. WARNING • Onl…

24, 24 F. Electrical Connection 1. Icemaker Power supply and ground connection are supplied from the remote condensing unit via the wire harness provided. The wire harness is factory connected to the icemaker. WARNING • Power supply and ground connection are supplied from the remote condensing uni…

37, 37 2. Remove the water from the water tank: 17) Remove the insulation panel and front frame. 18) Disconnect the hoses connected to the water tank. Allow the tank and hoses to drain completely. See Fig. 22. 19) Remove all ice from the dispenser unit/storage bin and clean the dispenser…