Elk ELK-129 Hardware User Manual

1, 1 PO Box 100 • Hildebran, NC 28637 • 800-797-9355 • 828-397-4200 Fax 828-397-4415 • www.elkproducts.com • [email protected] Computer Sound Card Interface The ELK-129 Computer Sound Card Interface allows a computer’s speaker output to be used as one of the tools for…

2, 2 129 Overview APPLICATION All ELK Voice Recordable Annunciator Modules can record & store voice, music or sound effects for later playback. There are basically two methods to record sound into the Recordable Modules; 1st is by pressing the Recordable Module’s Record Switch and speaking dire…

3, 3 129 Software Installation (ELK-120/124 ONLY) NOTE: The following ELK-129 “Waveloader” software installation is not required for the ELK-MM447 or ELK-MV480 modules which are programmed through the Magic Module Programming Software. See previous page. If you have an ELK-120 o…

4, 4 Refer to Figure 1 when making the following connections: 1. Strip the ends of the 2-conductor wire and connect one end to the step down transformer and the other end to the AC terminals on the ELK-129 (located under the cover). Plug the transformer into an AC receptacle. To confirm the power c…

5, 5 Figure 1. Hookup (ELK-120/124 ONLY) To Computer Speaker Out To Amplified Speakers To 12V 20VA Transformer 12V 20VA ELK Recordable Module (ELK-120 or ELK-124) 8 OHM SPEAKER (To listen to the module's playback) . . . . . 1-Ft. Ribbon Cable AUDIO OUT AUDIO INSW1 Computer Soun…

6, Elk ELK-129 6 NOTE: This section explains how to program an ELK-120 or ELK-124. For other ELK Recordable Modules models, please refer to the installation instructions that accompany the Recordable Module. If you have completed the hookup and software installations, you are ready to program your…