Hudson Boat Owner's Manual

33, 33 Then tip the stern end down into the slot, and slide the fin to the stern. This will lock the stern end of the fin in. Using the provided allen key, you can replace the set screw to keep the fin from sliding out. While if is not necessary (as the fin box is sealed), you can us…

17, Hudson Boat 17 Spread (Sculling) All sculling boats are coming out of the factory with stickers marking the spread measurements. To adjust using the factory stickers: • Insert the pin in the pin block so the pin key sits in the slot (See photo next page top left). If you tend to r…

29, 29 FAQ’S - RIGGER DIMENSIONS What are the dimensions for my rigger? How do I measure them? All riggers produced after 2002 have a stamping on them designating the dimension(s). SWEEP Sweep riggers have one number stamped on the sweep angle mount. This number…

32, 32 FAQ’s – Replacing the new fin How do I replace the new fin? Our fins have always been designed to break away under impact. Our new fin/finbox system make the fin immediately replaceable, as they do not require silicone to keep them in place. Begin by clearing the f…

8, 8 PARTS Please use this section to help identify the parts referred to in this manual. Foot assembly (without shoes and shoe Plate) Foot Stretcher End Piece Toe Bar Notched Channel (side) Hairpin Notched Channel (Centre) ¼” x ½” Bolts (they thread in…