Humminbird 300 series Operation Manual

28, 48 47 Triplog Reset (with Temp/Speed) Triplog Reset resets the Triplog to zero, and will appear in the menu if a Temp/Speed Accessory is connected and the paddlewheel has moved at least once. The Triplog provides the following information: timer for elapsed time, distance traveled since …

5, 4 3 The power output is the amount of energy generated by the sonar transmitter. It is commonly measured using two methods: • Root Mean Square (RMS) measures power output over the entire transmit cycle. • Peak to Peak measures power output at the highest points. The benefits of increased powe…

22, 36 35 Zoom Width Zoom Width adjusts the width of the Zoom window on the Sonar Zoom View. T o c hange the Zoom Width Setting: 1. Highlight Zoom Width on the Sonar main menu. 2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Zoom Width setting. (Narrow, Medium, Wide, D…

19, 30 Bottom Range (Sonar Zoom View only, when Bottom Lock is On) Bottom Range allows you to control how much of the water column, measured up from the bottom, is shown in the Sonar Zoom View. Choose a small value to see low- lying bottom structure or details of the bottom return. Choos…

20, Humminbird 300 series 32 Beam Select Beam Select sets which sonar returns from the transducer will be displayed on the screen. When set to 200/83 kHz, the returns from both beams are blended by starting with the 83 kHz wide beam return, dimming it, and then overlaying it with the 200 kHz narrow beam r…

31, 54 53 Finding the Cause of Noise Electrical noise usually affects the display with many black dots at high speeds, and high sensitivity readings. One or more of the following sources can cause noise or interference: Possible Source of Noise Isolation Other electronic devices The boat’s engine C…