Hussmann IMPACT RL Installation Instructions Manual

1, NOTES: Acrylic partitions are most often used in a line-up to separate cases with different refrigeration defrost cycles, and are installed as cases are joined. Joining instructions are provided separately. Be sure merchandisers have been leveled according to the installation ins…

2, 2 Position the Top Left Retainer — 1 against the edge of the interior top panel of left case as shown in Figure 2. Fasten with Screws — 2. Note: A factory-installed acrylic partition may have a retainer attached to the back end frame and partition. It is not used in field installatio…

3, Hussmann IMPACT RL 3 Loosely fasten the Acrylic Partition — 3 and Top Right Retainer — 4 to the Left Top Retainer using Screws — 5, Washers — 6, and Locking Nut — 7 as shown in Figure 3, Detail A. 4 Fasten the Top Right Retainer — 4 to the interior top panel of right case using Screws — 2. …

4, 5 Position the Bottom Left Retainer — 8 and Bottom Right Retainer — 9 at the bottom of the partition and around both end frames as shown in Figure 5. Fasten with Screws — 5, Washers — 6, and Locking Nut — 7 as shown in Figure 5. P/N 0332429A Merchandisers ® 4 HUSSMAN…

5, 6 Position the Top Front Left Retainer — 10 and Top Front Right Retainer — 11 at the top of the partition as shown in Figure 5. Fasten with Screws — 5, Washers — 6, and Locking Nut — 7. Fasten the top of the retainer with the cap screw used to join the cases. Acrylic Partition f…

6, 7 Position the Closeoff Retainer — 12 at the bottom of the partition as shown in Figure 6. Fasten with Screws — 5, Washers — 6, and Locking Nut — 7. Return to the joining instruction for fastener tightening sequence, joint molding installation and other steps necessary to complete…