Hyperion EOS 1210i Operation & User’s Manual

1, Hyperion EOS 1210i Hyperion EOS 1210i Charger User’s Manual for 1210I-A with A123 Mode Warnings: The EOS 1210i is a carefully-designed charger with many built-in safety features, such as reverse polarity protection, input voltage error warning, and cell-count mismatch warnings for lithium chemistry…

2, Memory Position and Settings per Battery Type The “Auto” modes for NiCd and NiMh battery types are preferred whenever you have a battery pack made from quality cells and in good condition and balance. The EOS 1210i charges NiCd and NiMH in Auto Mode based on an intelligent algorithm whi…

3, when using A123 Mode. The original Hyperion EOSLBA10 can be used, but was originally designed for Lithium Polymer batteries. The EOSLBA10 Balancer function works well with A123, but the overcharge and discharge protection voltages are higher than optimal for A123. For best results, …

4, Once you are satisfied that all the settings in the current memory position are correct for your battery, you are ready to charge, discharge, or cycle your pack! Note: When an LBA10 or compatible balancer is not connected to the 1210i via DataPort, the initial screen after charge is sta…

5, Charging in Excess of 1C Rate: Every Hyperion lithium polymer battery ever produced is capable of reliable charging in excess of 2C. Yet, until recently , Hyperion has only ever specified 1C charge rates. Why? Because extensive test and our experience have shown the following: • C…

6, * The DataPort version EOS chargers, when connected to LBA10 balancer via cable #HP-EOSLBA10-DPC, allow the user to monitor the individual voltages of each battery cell during the charge process. This is an important addition to pack diagnostics, as one is able to see the exact ba…