IMC Networks McPC 10 Operation Manual

20, 19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2009 IMC Networks. All rights reserved. The information in this document is subject to change without notice. IMC Networks assumes no responsibilit…

2, IMC Networks McPC 10 ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B computing device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when t…

15, 12 When the McPC 10/100 is in one of the Force modes, enable LFD by setting 5 to the ON position. Disable LFD by resetting 5 to its default, OFF , position. In order for LFD to function properly, Force mode must be enabled by setting 7 to ON with either 8 ON for 10 Mbp…

17, 14 Specifications (PCI and ISA Versions) Environmental Operating Temperature 32° - 104° F (0° - 40° C) Storage Temperature 0° - 160° F (-20° - 71° C) Humidity: 5 - 95% (non-condensing) Current Draw: 0.7A @ 5VDC Electrical Input Load 5V IMC Networks Technical Suppo…

13, 10 Modes of Operation (ISA Version) The McPC 10/100 features three modes of operation: Auto Negotiation mode , Force-10 mode and Force-100 mode . Configure the McPC 10/100 for one of these modes (factory default is Auto Negotiation mode). Refer to the Link Fault Detection secti…

16, 13 LED Indicators (ISA Version) The McPC 10/100 features four diagnostic LEDs. The following are the LED functions on the twisted pair port: Crossover/Pass- TX Link TX 100 Mbps Activ…