Infiniti M35h HYBRID 2013 Dismantling Manual

36, 4-1 Jump Starting Procedures NOTE: Jumper cable connections under the hood of the M35h HYBRID are not connected directly to a battery. They are connected to chassis ground and a fuse box terminal. Refer to the following instructions and the above illustration. 1. If the booster battery is in an…

5, 1. About the INFINITI M35h HYBRID This hybrid electric vehicle (HEV) uses two types of batteries. One is a 12V battery that is the same as the battery in vehicles powered by internal combustion engines. The 12V battery is located behind the rear seat back with battery cable access th…

33, 3-3.3 Water Submersion Damage level of submerged vehicle may not be apparent. Handling a submerged vehicle without appropriate PPE will result in serious injury or death from electrical shock. • The ignition switch of the submerged vehicle must be turned OFF first, if possible. Th…

39, 6. Dismantling Information Removal or repair of the high voltage battery requires special tools and specific training. INFINITI strongly recommends that only certified INFINITI retailer technicians perform these operations. 6-1 Precautions for Handling High Voltage Lithium-ion (Li-ion) Battery •…

31, SRS Air Bag System Components Location The SRS air bag system must not be cut as there is a risk of short circuit and unintentional deployment of the SRS However, the vehicle can be cut (except inflators) under the following conditions: • The front, side and curtain air bags have deployed. �…