InFocus ScreenPlay 5000 Operation & User’s Manual

30, 28 Settings menu Audio: allows adjustments to the volume and mute, and turns the projec- tor’s startup Chime on and off. Sources: allows you to assign a particular input to a specific source key on the remote. Also allows selection of a default Startup Source and enables or disables Autoso…

38, 36 Red LED behavior and projector errors If the projector is not functioning properly and the red LED is blinking, con- sult Ta b l e 2 to determine a possible cause. There are two second pauses between the blinking cycles. Visit our website for more details on the red LED error codes. See th…

13, 11 Connecting a computer Connect either a VESA cable or M1 cable into the appropriate connector on the projector (Vesa 1 o r DVI 2 ). Connect the other end to the video port on your computer. If you are using a desktop computer, you first need to dis- connect the monitor cable from …

4, 2 Table of Contents Introduction 4 Positioning the projector 6 Video connections 7 Connecting a video device 8 Displaying a video image 9 Connecting a computer 11 Shutting down the projector 12 Troubleshooting your setup 12 Using the keypad buttons 19 Using the remote control 20 Using th…

41, 39 Limited Warranty Subject to the Limitations, Exclusions and Disclaimers hereof, InFocus Cor- poration (“InFocus”) warrants that the Projector, Lamps and Accessories (hereinafter collectively or individually referred to as “Product” as appro- priate) purchased from InFocus, an InFo…

11, InFocus ScreenPlay 5000 9 Displaying a video image Remove the lens cap. Press the Powe r button on the top of the projector or the remote. The fans start to run. When the lamp comes on, the startup screen is dis- played. It can take a minute for the image to achieve full brightness. ? No startup screen?…