Innotech SpitFIRE I Operation & User’s Manual

5, SpitFIRE On-Screen Control Innotech Systems Inc. Page 5 Figure 1: Default On-Screen Display The on-screen LED will flash appropriately and a box on the left displays status messages received back from the SpitFIRE. Customizing the Display The appearance of the remote control is determined…

4, SpitFIRE On-Screen Control Innotech Systems Inc. Page 4 Installing SpitFIRE On-Screen Control Software 1. It is recommended that you close all running software applications before you install the SpitFIRE On- Screen Control Software. 2. Connect the SpitFIRE to the desired COM port (COM1 or CO…

7, Innotech SpitFIRE I SpitFIRE On-Screen Control Innotech Systems Inc. Page 7 Appendix a. To operate the SpitFIRE, you must set the appropriate COM port (COM1 or COM2) to 2400 baud, 8 data bits, no parity, 1 stop bit. This should be automatically accomplished by the software. If it is necessary to manually set the c…

1, INNOTECH SYSTEMS INC. Universal Infrared Remote Control From any PC! "SpitFIRE" Serial Port Interface IR EngineSerial Port Interface IR Engine On-Screen Control On-Screen Control Software Software User’s GuideUser’s Guide …

3, SpitFIRE On-Screen Control Innotech Systems Inc. Page 3 INTRODUCTION Congratulations on purchasing your SpitFIRE™ Serial Port Infrared Remote Control. The Innotech Systems’ SpitFIRE turns an ordinary PC into a powerful state-of-the-art home entertainment control system! The SpitFIRE con…