InSinkErator Ultra System Owner's Manual

1, Installation, Care & Use Instalacion, Cuidado & Uso Installation, Sion & Utilisation Owner’s Manual The Emerson logo is a trademark and a service mark of Emerson Electric, Co. InSinkErator is a division of Emerson Electric, Co. 44062 0407 www.insinkerator.com Printed in USA ©2007 In…

2, Lock Washer Hex Nut Deck Plate Metal Mounting Plate UW/UWL Tank 3/4" Screws (2) Snap-Connect Fitting (3 pieces) Plastic Mounting Gasket 3 HOW TO USE THIS INSTRUCTION MANUAL Provides a step-by-step narrative describing the installation step, with check boxes that can be marked as you progress …

3, Deck Plate Mounting Gasket Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing. 2 Q Unpack faucet components. Q On a firm, flat surface, carefully straighten the copper tubing. A C D INSTALLING THE FAUCET 5 Q Slide plastic mounting gasket over all tubes…

4, 7 Property Damage: Join remaining tube to cold water supply only. A 5 Q It is recommended that the water connection be made using a shutoff valve (not supplied). Q Where plumbing codes permit, a saddle valve (not supplied) can be used to supply water to the faucet. Follow the directi…

5, InSinkErator Ultra System 9 Scalding Hazard: Do not allow water to boil. May result in severe burns. Tank temperature is factory preset to 200°F,which mixes with cool tap water to produce an output water temperature of approx. 110°F. To reset the tank thermostat to 200°, turn the indicator one notch to …

6, 10 TROUBLESHOOTING WHAT TO DO Water and steam spits forcefully from spout without turning on the faucet. No warm water • Water is boiling in storage tank. May be normal during initial setup. • The unit is unplugged. • The electric outlet is inoperative. • Lift faucet lever to r…