StorageWorks 410 Installation Manual

51, Getting Started - RAID Array 410 for Windows NT – Intel EK–SMRAC–IG. C01 4–7 Figure 4–7 Format Menu 6. Continue to format each new partition until all partitions have been formatted. 7. When all partitions have been formatted, close Disk Administrator. At this point, the configuration ha…

15, Chapter 1. Unpacking and Setting Up Your RAID Array 410 Subsystem Components EK–SMRAC–IG. C01 1–3 Figure 1–2 Unpacking the RAID Array 410 Figure 1–3 Installation of Ramp on Shipping Pallet …

45, EK–SMRAC–IG. C01 4–1 4 Completing your Configuration Setup under Windows NT This chapter contains instructions for how to complete your configuration set up through Disk Administrator under Windows NT. 4.1 Completing Configurations under Windows NT In order for Windows NT to recognize new RAI…

3, StorageWorks 410 EK–SMRAC–IG. C01 iii Contents Revision Record ......................................................................................................v About This Guide..................................................................................................vii Getting Started .......…

24, Getting Started - RAID Array 410 for Windows NT – Intel 2–2 EK–SMRAC–IG. C01 You need the following before you begin: • The appropriate host adapter (SWIA3-BB or SWXA3-BC). Use precautions to protect the board from static discharge. • Your computer system hardware manual • …

37, Chapter 3. Installing and Using the RAID Array 410 Manager for Windows NT EK–SMRAC–IG. C01 3–7 Figure 3–5 Updated Physical View 3.6.2 Practice Example: Creating a Single Disk Click on the Configure button near the top of the main window. Doing so displays three configuration butt…