Intergraph ErgoView Stand Installation Manual

11, Intergraph ErgoView Stand 7 Screws (2) Adapter Bracket Holding Latch 2. Secure the adapter bracket to the monitor using the two screws removed from the swivel base. Replacing the Monitor Collar The monitor collar shipped on the ErgoView stand is designed for CLIX workstation monitors only. You m…

5, 1 1 ErgoView Stand Installation This document describes how to install single- or dual-monitor ErgoView workstation stands with digitizing table configurations. Read all of the instructions completely before beginning the installation. WARNING The following procedures are to be per…

20, 16 For a Hamilton base, connect the AC adapter cable (MCBLT73) to the existing Hamilton base power cord. NOTE The base power cord is permanently attached to the Hamilton base. AC Adapter Cable Base Power Cord 2. Remove the AC receptacle cover from the ErgoView stand as shown in the followi…

12, 8 2. Attach the rear mounting bracket (CFAB331F) to the collar using four M4x8mm screws. Monitor Collar Rear Mounting Bracket Cover Plate Screws (4) 3. Set the monitor into the collar. WARNING Ensure that one person holds the top of the monitor to prevent it from tipping downward when init…

10, 6 4. Thread the two M3x12mm Phillips pan head screws with M4 oversized washers through the collar tabs and into the monitor housing. Do not tighten the screws yet. 5. Thread the four M5x25mm Phillips flat head screws through the bottom of the cover plate (attached to the bottom of t…