Intergraph RealiZm Graphics Z10 Hardware User's Manual

21, 9 10. Insert the two screws previously removed to secure the two I/O panels together. 11. Install the new Z10-T board set in the open PCI slot and in the slot from which you removed the previously installed Z10 board. 12. Install the screws that were previously removed to secure the Z10-T boar…

16, Intergraph RealiZm Graphics Z10 4 Configuring Display Properties To enable your system to use its installed graphics board, you must configure the video display driver to use the RealiZm graphics accelerator. Intergraph installs the video display driver on the system’s hard disk drive. The Display Properties dialo…

46, 34 The Frame Buffer features: Video planes True-color image buffer High-resolution Z buffer Stencil buffer (Z13, Z25, and V25) Alpha buffer (Z13, Z25, and V25) Multiple video lookup tables Window-mode double buffering Gamma correction Hardware cursor Stereoscopic viewing Multiple…

48, 36 Sub-Pixel Accuracy The Graphics Engine uses sub-pixel accuracy for improving the quality of the graphics image. Sub-pixel accuracy ensures adjacent polygons and vectors join smoothly. Window Clipping (Z13, Z25, and V25) While rendering triangles and vectors, the Graphics Engine discards pixels…

71, 59 Dedicated 60-pin ribbon cable interface Peak transfer rate of 132 MB per second Up to two graphics board sets can be interfaced to a single Geometry Accelerator board Monitor Resolutions Z10, Z13, Z25, and V25 supports standard multi-sync monitors, including the Intergraph 17-inch and 21-in…

11, xi Getting Telephone Support If you experience problems with your Intergraph product, or have questions about the information in this document, you can contact Intergraph for help. In the United States, call the Customer Response Center at 1-800-633-7248 between the hours of 7…