Intergraph TD-x10 Setup Setup Manual

2, Warranties and Liabilities The information and the software discussed in this document are subject to change without notice and should not be considered commitments by Intergraph Corporation. Intergraph Corporation assumes no responsibility for any errors in this document. The software discus…

6, Intergraph TD-x10 Setup vi Configuring Support for Heidi Graphics .......................................................................... 27 Correcting Video Display Problems................................................................................. 28 Configuring Networking..................................…

53, 41 DMA Channel x Usage These parameters specify whether a given DMA channel is to be reserved for an ISA card, or is free to be assigned to another device by the PnP BIOS. The options are PnP (default) and ISA. IRQ x Usage These parameters specify whether a given IRQ is to be reserved for an IS…

69, 57 6 Installing System Software Follow the instructions in this chapter if you have to re-install the operating system and associated system software on your Intergraph TD-x10, TDZ-x1x, or TDZ-612 RAX system. NOTE For instructions on installing the Solaris 2.5 for x86 operating system, refer to…

58, 46 NOTE TD-310, TDZ-310, TD-410, and TDZ-410 systems use the 752 xx .ROM BIOS, and TD-610, TDZ-610, TDZ-612, and TDZ-612 RAX systems use the 782 xx .ROM BIOS, where xx is the version number. The FPU is an MS-DOS utility that will not run in the Windows NT environment. The system must be set t…