Intergraph InterServe 80 SL System Reference Manual

29, 17 5. Do all of the following: − Note the SCSI ID jumper settings on the old drive. − Set the SCSI ID on the new drive to the same ID as the old drive. − Disable termination on the new drive. See Chapter 6, “Peripherals,” for details on these tasks. 6. Place the disk drive in …

30, 18 Internal Bay Disk Drives To replace an internal bay disk drive: 1. Disconnect the SCSI cable and power cable from the disk drive. 2. Remove the two screws that secure the drive bracket assembly to the left side of the chassis. 3. Grasp the drive bracket assembly and remove the s…

44, Intergraph InterServe 80 SL 32 SCSI Termination Guidelines for External Devices ........................................44 Connecting an External SCSI Drive ...............................................................44 Changing SCSI Host Adapter or Device Settings........................................…

84, 72 System Model Number The model number on the unit identifies the system hardware and software configuration. The following table defines the individual digits. Digit Meaning 1: Series 5: InterServe 80 SL 2: Processor Type 0: No processor U: Single Intel Pentium II, 266 MHz, 5…

69, 57 J7, J8 - MCBL121A, EIDE Data Cable Pinout Pin Signal Pin Signal Pin Signal 1 BRSTDRV- 15 D01+(1) 28 VCC 2 Ground 16 D01+(14) 29 DOAK0- 3 D01+(7) 17 D01+(0) 30 Ground 4 D01+(8) 18 D01+(15) 31 IRQ14 5 D01+(6) 19 Ground 32 IOCS16- 6 D01+(9) 20 — 33 DA1 7 D01+(5) 21 D0RQ0- 34 — 8 D01+(1…

5, v Contents Preface.........................................................................................................................ix About This Document.................................................................................................. ix Document Conventions........…