Intergraph InterServe 90 System Reference Manual

34, 26 Before You Begin WARNING Disconnect the system and peripheral devices from AC power before servicing internal components! Failure to remove AC power may result in equipment damage or personal injury. WARNING Follow all warnings and cautions in the servicing instructions. If you fail …

29, 21 To replace the chassis fan: 1. Disconnect the fan power cable from the power supply connector. 2. Remove and retain the four screws attaching the fan and fan grille to the chassis. 3. Ensure the airflow direction arrow on the new fan is pointing in the correct direction, then attach the new…

32, Intergraph InterServe 90 24 2. Remove the two screws that secure the switch to the tab on the front of the chassis and remove the switch. 3. Align the new switch with the chassis mounting holes and install the screws. 4. Connect the wires to the same locations noted in Step 1. …

56, 48 Internal Peripheral Device Cables The following describes internal peripheral device cables, their connectors, and the locations in the system to which they connect. Cable illustrations are not to scale. You can identify the cables and connectors using their spacing as a reference. S…

62, 54 Specifications Item Specifications Dimensions 16.7 in. wide x 25 in deep x 10.5 in. tall Maintenance clearance 36 in ches (91.4 cm) front and back AC line voltage (US) 90 - 132 VAC, 47 - 63 Hz, 1 phase, 15A/125 V receptacle AC line voltage (International) 180 - 264 VAC, 47 - 63 Hz, 1 phase, …

53, 45 The power supply fan is not field replaceable. If the power supply fan requires replacement, you must replace the power supply. RAID/JBOD Cooling Fan Specifications The RAID/JBOD disk drive bay also has two cooling fans mounted behind the disk drive bay. The table below summarizes fan…