iPort IW-1 Instruction Manual

7, iPort IW-1 7 iPort ver. IW Instruction Manual 7. Use a stereo RCA audio cable to connect the iPort Wallplate to a source input on the local-zone audio system. 8. After installing the iPort in the wall (see Installing the iPort in a Wall, page 9), plug the power supply into a wall outlet. iPort System…

14, 14 iPort ver. IW Instruction Manual WARRANTY COVERAGE (U.S. ONLY) iPort provides the following coverage for units that fail under normal use and according to these instructions due to a defect in workmanship or materials: For units installed inside a residence, iPort will, at its opt…

5, 5 iPort ver. IW Instruction Manual iPort System Connections — IW-1 / IW-2 See Figure 3 IW-1 and IW-2 systems’ unbalanced audio output is designed for use in a local-zone system where the audio equipment is locat- ed less than 20 feet from the iPort. In IW-1 systems the iPod is contr…

13, 13 iPort ver. IW Instruction Manual Technical Assistance and Service If you any have questions about the operation or installation of this product, please call our Technical Assistance Department at (800) 582-0772 or (949) 492-7777; from 7 a.m. to 5 p.m., Pacific Time, Monday – …

6, iPort ver. IW 3a. If the system includes a #70071 or #70072 line- level volume control, set the iPort’s Volume Control YES/NO switch to the right ( YES ) position (volume control in system). 3b. Use 5-conductor twin-shielded wire to connect the volume control to the iPort 5-pin connector…