Jandy JPL1230 Installation And Operation Manual

19, Jandy JPL1230 Page 19 9.2 Jandy Digital Spa Light 12345 6 7 89 10 Figure 10. Jandy Digital Spa Light Exploded View DWG# Part# Description Field Replaceable 1 N/A Spa Light Housing NO - Purchase New Light 2 N/A Transformer (120 Volt lights only)-Spa NO - Purchase New Light 3 N/A Bulb Holder and Electronics Asse…

8, Page 8 5. Coil the 4-foot length of cord around the fi xture and place the light assembly into the niche. 6. Engage the retainer tab on the bottom of the face ring, then pivot the top of the fi xture inward and tighten the special pilot screw. WARNING Use only the special pilot screw …

4, Page 4 Section 1. Safety Information IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS READ AND FOLLOW ALL INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, includi…

15, Page 15 4. Disassemble the light fi xture and replace bulbs. Use the following bulb removal instructions for Jandy Pool and Spa Light: a. a. Loosen the Phillips head screw on the band clamp to allow the clamp to be removed. Screw should Loosen the Phillips head scr…

7, Page 7 2. To be certain that the pool or spa’s electrical system meets all applicable requirements, the electrician should also consult the local building department. 3. Use only approved wet niches (see following note) to ensure a safe and proper installation. NOTE Jandy Poo…

17, Page 17 Section 8. Twelve (12) Volt Installation A separate 12-Volt AC Transformer is required on all 12-Volt Models--For Jandy Pool Light use a 300-watt multi tap 12-volt system. For the Jandy Spa Light, a 100 watt 12-volt system is acceptable. To ensure maximum safety, it is stro…