Jaton 3DForceG-16 Operation & User’s Manual

25, 25 9. A screen message prompt that the conformation of your display driver has been in place for the new hardware. Click on “Yes”. 10. Click on “OK”. Once the driver files are copied, RESTART Microsoft Windows NT 4.0 for the changes to take effect. 7.1.3 ÿÿ MICROSOFT WIND…

6, 6 2. Features 2.1 AGP Bus Interface • Full AGP 2X/4X Support at up to 1.06 GByte/sec transfer rate • DMA bus mastering support with Scatter Gather • Execute Mode for Direct Textures, Video, and DVD • Special impedance matching circuit for AGP-4X signaling 2.2 Performance …

9, 9 • Capable of supporting HD0 HDTV resolution (1280x720) • TrueVideo® bilinear interpolation with proprietary edge recovery scaling • Dual apertures for simultaneous access to graphics and video display memory area • Dual color space converters (CSC) • Accelerates YUV p…

39, 39 Q: Windows screen won’t come up, it kicks back to DOS prompt. Why? A: The SYSTEM.INI file may contain different information with the system hardware, cause by the new integration or the new installation of a video adapter. The SYSTEM.INI file is located in the WINODWS\SYSTE…

38, Jaton 3DForceG-16 38 10. Click on “Finish” to complete the driver installation. 8. Technical Assistance (Q & A) Q: Why is the display shifted or changed sizes when I switch display modes? A: Some monitors lack auto-sizing features or just do not synchronize properly to the video board outpu…

45, 45 10. Pinout and Sync Frequencies 10.1 Analog Color Display Pinouts (DB 15) PIN FUNCTION 1 Red Video 1 2 Green Video 1 3 Blue Video 1 4 Not Used 5 Ground 6 Red Return (ground) 7 Green Return (ground) 8 Blue Return (ground) 9 Vcc (+5v DDC Power) 10 Sync Return (ground) 11 Monitor ID (…