Jeep Grand Cherokee Operation & User’s Manual

51, Jeep Grand Cherokee Jack Location • The scissor-type jack and tire changing tools are located in the passenger side compartment, behind the second row seat. Spare Tire Stowage • To remove or stow the spare, use the jack handle to rotate the “spare tire drive” nut which is located under a plastic cove…

53, • For rear wheels, place it under the axle near the wheel to be changed. 51 WHAT TO DO IN EMERGENCIES …

71, • The Integrated Power Module (IPM) is located in the engine compartment near the battery. This center contains cartridge fuses, mini-fuses and relays. Cavity Cartridge Fuse Mini-Fuse Description 8 10 Amp Red Lt Park Lamps 9 10 Amp Red Trailer-Tow Park Lamps 10 10 Amp Red Rt Park Lamps 12 2…

59, TOWING A DISABLED VEHICLE Model Flat Towing (all four wheels on the ground) Flatbed Towing (all four wheels suspended OFF the ground) Front Wheels Raised, Rear Wheels on the Ground Rear Wheels Raised, Front Wheels on the Ground Two-wheel drive - Transmission not operable Remove th…

23, • Once a speed is set, tapping the lever up or down will increase or decrease the set speed approximately 1 mph (2 km/h). Cancel • Pull the lever toward you or apply the brakes to cancel the set speed and maintain the set speed in memory. • Push the ON/OFF button to turn the system off…

54, • Turn the jack screw clockwise to firmly engage the jack saddle with the lift area of the sill flange. • Raise the vehicle by turning the jack screw clockwise. Raise the vehicle only until the tire just clears the surface and enough clearance is obtained to install the spare tire. WARNING! …