Jenn-Air JMW2327W Manual, Product Dimensions

PRODUCT MODEL SERIES PRODUCT DIMENSIONS
JMW2327W
JMW2330W
JMW2427W
JMW2430W
JMW3430W
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine
that the ground path and the wire gauge are in accordance
with local codes.
Check with a qualified electrical installer if you are not sure
the oven is properly grounded.
This oven must be connected to a grounded metal,
permanent wiring system.
Be sure that the electrical connection and wire size are
adequate and in conformance with the National Electrical
Code, ANSI/NFPA 70-latest edition or CSA Standards C22.1-
94, Canadian Electrical Code, Part 1 and C22.2 No. O-M91-
latest edition, and all local codes and ordinances.
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the
instructions provided for it here.
● 
Oven must be connected to the proper electrical voltage
and frequency as specified on the model/serial number
rating plate. The model/serial number rating plate is located
near center vent of the lower oven. See the following
illustration.
● 
Models rated from 7.3 to 9 kW at 240 volts (5.4 to 7.4 kW
at 208 volts) require a separate 40-amp circuit. Models
rated at 4.8 kW and below at 240 volts (3.6 kW and below
at 208 volts) require a separate 20-amp circuit.
● 
A circuit breaker is recommended.
● 
Connect directly to the fused disconnect (or circuit breaker
box) through flexible, armored or nonmetallic sheathed,
copper cable (with grounding wire). See “Make Electrical
Connection” section.
● 
Flexible conduit from the oven should be connected directly
to the junction box.
● 
Do not cut the conduit. The length of conduit provided is
for serviceability of the oven.
● 
A UL listed or CSA approved conduit connector must be
provided.
● 
If the house has aluminum wiring follow the procedure
below:
1. Connect a section of solid copper wire to the pigtail
leads.
2. Connect the aluminum wiring to the added section of
copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with
local codes and industry accepted wiring practices.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10221384B
08-18-2009
27" (68.6 CM) AND 30" (76.2 CM) 
ELECTRIC BUILT-IN MICROWAVE/OVEN COMBINATION

Product Dimensions
 Cabinet Dimensions
 27" (68.6 cm) models
A. 25
¹⁄₄
" (64.1 cm) max. recessed 
width
B.
43¹⁄₁₆
" (109.4 cm) max. overall 
height
C. 26
³⁄₄
" (67.9 cm) max. overall 
width
D. 23
⁵⁄₈
" (60.0 cm) max. overall 
depth
E. 41" (104.2 cm) max. recessed 
height
 30" (76.2 cm) models
A. 28" (71.1 cm) max. recessed 
width
B.
43¹⁄₁₆
" (109.4 cm) max. overall 
height
C. 29
³⁄₄
" (75.6 cm) max. overall 
width
D. 23
⁵⁄₈
" (60.0 cm) max. overall 
depth
E. 41" (104.2 cm) max. recessed 
height
E
C
D
B
A
 27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet width
B. 43
⁵⁄₁₆
" (110.0 cm) from bottom 
of cutout to bottom of upper 
cabinet door
C. 19
¹⁄₄
" (48.9 cm) recommended 
bottom of cutout to floor. 4" 
(10.2 cm) to 19
¹⁄₄
" (48.9 cm) 
bottom of cutout to floor is 
acceptable.
D. 25
¹⁄₂
" (64.8 cm) cutout width
E. 1
¹⁄₂
" (3.8 cm) min. bottom of 
cutout to top of cabinet door
F. 4 1
¹⁄₄
" (104.8 cm) cutout height 
G. 24" (61.0 cm) minimum cutout 
depth
 30" (76.2 cm) models
A.
30
" (76.2 cm) min. cabinet 
width
B. 43
⁵⁄₁₆
" (110.0 cm) from bottom 
of cutout to bottom of upper 
cabinet door
C. 19
¹⁄₄
" (48.9 cm) recommended 
bottom of cutout to floor. 4" 
(10.2 cm) to 19
¹⁄₄
" (48.9 cm) 
bottom of cutout to floor is 
acceptable.
D. 28
¹⁄₂
" (72.4 cm) cutout width
E. 1
¹⁄₂
" (3.8 cm) min. bottom of 
cutout to top of cabinet door
F. 4 1
¹⁄₄
" (104.8 cm) cutout height
G. 24" (61.0 cm) minimum cutout 
depth
A
B
C
D
E
F
G

A

. Model/serial number plate (located on 
underside of center vent)
A

ELECTRICAL CONNECTION

• 
  LG 32LH240H

  #W46567: 32LH240H Document

  32LH240H, 110, lg/32lh240h.pdf

• 
  Digimax UP-6ESS

  Digimax Tutorial: UP-6ESS (#57A82R)

  UP-6ESS, 2, digimax/up-6ess.pdf

• 
  CableCreation CD0029

  Media Converter CD0029 Document, #M7K9Z3

  CD0029, 5, cablecreation/cd0029.pdf

• 
  HOMEDEPOT StyleWell HS202006-34WTE

  HOMEDEPOT Indoor Furnishing Manual (#81SXZ2)

  StyleWell HS202006-34WTE, 17, homedepot/stylewell-hs202006-34wte.pdf

• 
  Samsung PL200

  Samsung Instruction: PL200 (#VY5DRQ)

  PL200, 40, samsung/pl200.pdf

• 
  JL Audio SB-K-SL

  Car Receiver Handbook #Q687MN

  SB-K-SL, 3, jl-audio/sb-k-sl.pdf

• 
  Mettler Toledo IND780

  Mettler Toledo User Manual: IND780 (#C9567Z)

  IND780, 102, mettler-toledo/ind780.pdf

• 
  Sharp ER-A320

  Sharp Cash Register Manual (#X341KG)

  ER-A320, 76, sharp/er-a320.pdf

• 
  Dietz SANGO ADVANCED Series

  Wheelchair User Manual #4I7UW9

  SANGO ADVANCED Series, 40, dietz/sango-advanced-series.pdf

• 
  Saluki S5105 Series

  Measuring Instruments User Guide #31936P

  S5105 Series, 204, saluki/s5105-series.pdf

• Search YouTube Videos for Jenn-Air JMW2327W Device
• Search Google for Jenn-Air JMW2327W Information
• Search Photo of Jenn-Air JMW2327W in Google Images
• Search Twitter for Jenn-Air JMW2327W News