Jonsered LT2116 Operator's Manual

16, 16 MAINTENANCE V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not ad just able. Re place belts if they begin to slip from wear. TRANSAXLE COOLING Keep transaxle free from build-up of dirt and chaff which can rest…

21, 21 02239 ADJUSTMENT BOLT NEUTRAL LOCK GATE GEARSHIFT LEVER FIG. 22 TRANSAXLE GEAR SHIFT LEVER NEU TRAL- ADJUSTMENT (See Fig. 22) The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however…

25, 25 TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine continues to run 1. Faulty operator-safety presence control system. 1. Check wiring, switches and connections. If not when operator leaves seat …

12, Jonsered LT2116 12 OPERATION TO OPERATE ON HILLS WARNING: Do not drive up or down hills with slopes great er than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills. • If stopping i…

15, 15 MAINTENANCE FIG. 9 TO SHARPEN BLADE (See Fig. 10) NOTE: We do not recommend sharp en ing blade - but if you do, be sure the blade is balanced. Care should be taken to keep the blade balanced. An un- balanced blade will cause excessive vibration and even tual damage to mower and engin…

17, 17 MAINTENANCE CLEAN AIR SCREEN Air screen must be kept free of dirt and chaff to prevent engine dam age from overheating. Clean with a wire brush or compressed air to re move dirt and stubborn dried gum fi bers. MUFFLER Inspect and replace corroded muffl er and spark arrester …