JPS Communications RTU-292 Installation And Operation Manual

80, RTU-292 Operations Manual 5.4.7 Elapsed Time Response %Connection dropped, elapsed time: hh:mm:ss Exx <CR> Type: Asynchronous. Response To: Completion of a Radio/Telephone call. This response indicates that a Radio/Telephone call has been terminated. The response shows the …

47, RTU-292 Operations Manual noise source is switched off, the LED is lit continuously, and the unit is ready for operation. This adaptation procedure normally takes less than one second. For adaptation to be successful, the far end …

33, RTU-292 Operations Manual occasionally on voice peaks. Note that the PEAK indicator responds only to incoming radio audio, not telephone audio. The range of the RX Level Adjust control is about -40 dBm to +10 dBm. If the level from …

55, RTU-292 Operations Manual Table 3-2 Programming Mode DTMF Commands These commands may be entered by the RTU-292 front panel keypad*, or by the keypad of a connected telephone or by a telephone set wired to the Local Phone Option. The u…

9, RTU-292 Operations Manual Glossary Adaptation The process whereby the RTU-292 DSP algorithms detect reflected signal information in a connected line and tune the DSP hybrid for a broadband null with minimum reflection. COR …

103, JPS Communications RTU-292 RTU-292 Operations Manual Table 7-6 VMM-100 SPECIFICATIONS GENERAL Frequency Response 100 to 3400 Hz +/- 2dB Input Level 0 dBm nominal Input Impedance Unbalanced 10k Ohm DSP Output Delay < 10mS Noise Reduction Type Dynami…