Hughes JVC Model 200 Service Manual

53, Chapter 2---System Description /LAMP_LIT Informs the SCB that the Arc Lamp is lit or not lit OUTPUTS DESCRIPTION /LAMP_ENA Enables ALPS power Projection Lens OUTPUTS DESCRIPTION LENS_FOCUS Signal to lens focus motor LENS_ZOOM Signal to lens zoom motor Front IR INPUTS DESCRIP…

82, Chapter 3---Service Adjustments Figure 3-2. Arc Lamp “Hot Spot” (whitest area) is off-center vertically and horizontally. Adjust to center the “hot spot”. 9. Insert a flathead screwdriver into one of the horizontal alignment slots shown in Figure 3-1 and pry back a…

127, Chapter 5---Troubleshooting error. If it occurs, copy the 3 lines that appear on the screen, note what occured just prior to this failure, and call Hughes-JVC. 5.3. Troubleshooting Guide Table 5-2 shows some common projector problems, what to check when problems occur, possible so…

19, Chapter 2---System Description light into its Red, Green and Blue components. The first mirror in the Dichroic Mirror Assembly reflects blue light to the blue ILA ® assembly, the second mirror reflects green light to the green ILA ® assembly, and the third reflects red light t…

134, Hughes JVC Model 200 Import/Export 2. Import will alter all projector setup data. Prior to starting, several warnings are displayed to prevent unintentional loss of setup data. 3. Model 200 Menu: 7. System + 5. Maintenance + 6. Import ================================= | WARNIN…

104, Chapter 4---Maintenance (Removal/Replacement) Figure 4-4. Lamphouse Dock and Arc Lamp with cover off. 7. When reinstalling the Arc Lamp, be sure that the Safety Shutter tab on the left side (Figure 4-4) engages the left side of the housing so that the Arc Lamp cooling door o…