Kidde I9070 Operation & User’s Manual

9, Kidde I9070 3. Installation Instructions To activate the battery carrier tamper resist feature, remove the unit from the trim plate and locate the small cut-out in the middle of the product label on the back of the unit. With a small screwdriver, or similar tool, slide the switch towards the top of the label…

6, 1. Recommended Locations for Smoke Alarms • Put smoke alarms at both ends of a hallway or large room if the hall- way or room is more than 30 ft (9.1 m) long. For large rooms, one smoke alarm is recommended for every 500 square feet of floor space. • In homes that are not well insulated, extr…

2, Smoke Alarm Procedure NEVER IGNORE THE SOUND OF THE ALARM! Smoke alarms are designed to minimize false alarms. Cigarette smoke will not normally set off the alarm, unless the smoke is blown directly into the alarm. Combustion particles from cook- ing may set off the alarm if it is located too clos…

15, 10. NFPA Required Protection The National Fire Protection Association’s Standard 72 provides the following information: Smoke Detection - Where required by applicable laws, codes, or standards for a specific type of occupancy, approved single- and multiple-station smoke alarms shall be…

8, 3. Make sure that the mounting screws are positioned in the small ends of the keyholes before tightening the screws. 4. Install the alarm on the mounting plate and rotate the alarm in the direction indi- cated by the "ON" arrow on the cover until the alarm ratchets into place (this ratche…

16, 12. Service and Warranty TEN YEAR LIMITED WARRANTY Kidde warrants to the original purchaser that the enclosed smoke alarm will be free from defects in material and workmanship or design under normal use and service for a period of ten (10) years from the date of purchase. The obligation of K…