Kodak SC4 Manual, Operating Instructions

Made in China for
EASTMAN KODAK COMPANY
Rochester, New York 14650 U.S.A.
© Eastman Kodak Company, 2010.  
MC/MR/TM: Kodak.
www.kodak.com/go/batteries        4H7389
KODAK 
4 Cell Smart Charger SC4
Operating Instructions
CHARGE INDICATOR LIGHTS
Red ........................Charging
Green....................Charging complete
Blinking Red ........Replace batteries
HOW TO CHARGE
1.  Place 2 or 4 AA, or 2 or 4 AAA size NiMH 
rechargeable batteries into the charger so that 
the + (positive) and – (negative) ends 
(terminals) of the batteries correspond to the 
same + and – markings in the charger.
    CAUTION: Do not use AA and AAA size 
batteries in the charger at the same time.
    When charging only 2 batteries, insert them 
together into either the left or right side of the 
charger.
2. Plug the charger into a power outlet. The 
charge indicator light is illuminated and 
battery charging begins. (NOTE: Do not insert 
or remove batteries during this charging 
process.) See Specifications for charging time.
After charging, the charger will regularly check 
battery voltage and turn on when needed to 
maintain a full charge.
Recommended Temperature Ranges
To use (discharge) the batteries: 
32 to 122°F (0 to 50°C)
To charge the batteries: 
32 to 104°F (0 to 40°C)
To store the batteries: 
-13 to 140°F (-10 to 20°C) 
41 to 59°F (5 to 15°C) — ideal
Pre-charged NiMH batteries must be stored in 
a cool, dry location.
Using the batteries outside the temperature 
ranges may shorten battery life and decrease 
eciency.
TIPS
•  For best performance, use only KODAK NiMH 
Batteries.
•  Charge the batteries before using (unless 
using pre-charged batteries).
•  Do not use charged and discharged batteries 
together.
SPECIFICATIONS
Input    100-240 V AC
    50/60 Hz  4W
Output  (AA)  DC 2.8 V - 310 mA 
  (AAA)  DC 2.8 V - 120 mA
Battery/Approx. Charge Times 
AA mAh  Time (hrs.)  AAA mAh  Time (hrs.)
2700  10.1 1000  9.7
2600  9.9    900  8.5
2500  9.5    850  8
2100 7.9
1800 6.8 
1700 6.4
IMPORTANT SAFETY 
INSTRUCTIONS—
Save These Instructions
•  DANGER—TO REDUCE THE RISK OF FIRE 
OR ELECTRICAL SHOCK, CAREFULLY 
FOLLOW THESE INSTRUCTIONS.
•  DANGER—CHARGE ONLY BATTERIES 
SPECIFICALLY MARKED AS 
RECHARGEABLE. OTHER TYPES OF 
BATTERIES MAY LEAK, RUPTURE, OR 
EXPLODE AND CAUSE PERSONAL INJURY 
AND DAMAGE.
•  CAUTION: Keep dry. Do not use extension 
cords with this product. Do not operate 
charger if it has been subjected to electrical 
or physical shock or other damage. Do not 
disassemble charger.
•  For connection to a supply not in the U.S.A., 
use an attachment plug adapter of the proper 
configuration for the power outlet. This 
battery charger is intended to be correctly 
oriented in a vertical or floor mount position.
•  This appliance is not intended for use by 
persons (including children) with reduced 
physical, sensory or mental capabilities, or 
lack of experience and knowledge, unless they 
have been given supervision or instruction 
concerning the use of the appliance by a person 
responsible for their safety.
•  Children should be supervised to ensure that 
they do not play with the appliance.
•  It is normal for batteries to become warm 
while charging.
SUPPORT
www.kodak.com/go/support
www.kodak.com/go/contact
Regulatory Information
FCC compliance and advisory
This device complies with part 15 of the FCC 
Rules. Operation is subject to the following two 
conditions: (1) This device may not cause 
harmful interference, and (2) this device must 
accept any interference received, including 
interference that may cause undesired 
operation.
This equipment generates, uses, and can radiate 
radio frequency energy and, if not installed or 
used in accordance with the instructions, may 
cause harmful interference to radio 
communications. However, there is no 
guarantee that interference will not occur in 
a particular installation.
If this equipment does cause harmful 
interference to radio or television reception, 
which can be determined by turning the 
equipment o and on, the user is encouraged to 
try to correct the interference by one or more of 
the following measures: (1) reorient or relocate 
the receiving antenna; (2) increase the 
separation between the equipment and the 
receiver; (3) connect the equipment to an outlet 
on a circuit dierent from that to which the 
receiver is connected; (4) consult the dealer or 
an experienced radio/TV technician for 
additional suggestions.
Any changes or modifications not expressly 
approved by the party responsible for 
compliance could void the user’s authority to 
operate the equipment. Where shielded 
interface cables have been provided with the 
product or specified additional components or 
accessories elsewhere defined to be used with 
the installation of the product, they must be 
used in order to ensure compliance with FCC 
regulation.
Canadian DOC statement
DOC Class B compliance—This Class B digital 
apparatus complies with Canadian ICES-003.
4H7389
+
–
Indicator Light
2 battery charge
4 battery 
charge
OR
EN

• 
  General Pump 2100306

  General Pump Document Pressure Washer 2100306 (#GS941F)

  2100306, 5, general-pump/2100306.pdf

• 
  Quantum FC420

  Adapter Instruction #MIPD21

  FC420, 30, quantum/fc420.pdf

• 
  Axis Geocalla G3-3D

  Axis Instruction Camera Accessories Geocalla G3-3D (#TU552F)

  Geocalla G3-3D, 7, axis/geocalla-g3-3d.pdf

• 
  ASA Electronics Voyager VCCS130HP

  Voyager VCCS130HP Automobile Accessories - #C6EB62

  Voyager VCCS130HP, 2, asa-electronics/voyager-vccs130hp.pdf

• 
  Eterna LEDREM3

  Lighting Equipment LEDREM3 Tutorial, #9727I2

  LEDREM3, 3, eterna/ledrem3.pdf

• 
  Ricoh PJ X3340

  Guide (PJ X3340, #72N7D3)

  PJ X3340, 2, ricoh/pj-x3340.pdf

• 
  CEMB TR-NC/8

  CEMB Transmitter Manual (#1FW3JF)

  TR-NC/8, 18, cemb/tr-nc8.pdf

• 
  Canon XL-H1 - 3CCD High Definition Camcorder

  Camcorder XL-H1 - 3CCD High Definition Camcorder User Manual, #MZJA59

  XL-H1 - 3CCD High Definition Camcorder, 18, canon/xl-h1-3ccd-high-definition-camcorder.pdf

• 
  SoftBank 006SH

  Cell Phone 006SH Guidance, #OO7728

  006SH, 100, softbank/006sh.pdf

• 
  Linksys WET200 - Wireless-G Business Ethernet Bridge

  WET200 - Wireless-G Business Ethernet Bridge Network Hardware - #N2QM9P

  WET200 - Wireless-G Business Ethernet Bridge, 4, linksys/wet200-wireless-g-business-ethernet-bridge.pdf

• Search YouTube Videos for Kodak SC4 Device
• Search Google for Kodak SC4 Information
• Search Photo of Kodak SC4 in Google Images
• Search Twitter for Kodak SC4 News