Kurzweil PC3 Musician's Manual

151, Setup Mode The Continuous Control Pedal (CPEDAL) Page 7-31 The Continuous Control Pedal (CPEDAL) Page If you look at the back of the instrument, you will see that there are two jacks for plugging in two CC (Continuous Control) pedals and a jack labeled Breath Controller. Like the nine program…

234, 12-10 Song Mode and the Song Editor Song Mode: The METRO Page The Done Soft Button If no changes were made in the MIXER page, pressing the Done soft button calls up the MAIN page. If changes were made, pressing the Done soft button calls up the “Save Changes” dialogue. Song Mode: The METRO…

139, Kurzweil PC3 Setup Mode Controllers 7-19 PitchDwn). Any physical controller that uses the Control Destination list can be assigned to PitchUp or PitchDwn. To keep things simple though, you will normally want to use BendUp as a Pitch Wheel destination and use AuxBend 1 and AuxBend 2 for other contro…

161, Setup Mode The Arpeggiator (ARPZON) Page 7-41 Random plays the currently latched notes in completely random order. Shuffle plays them at random, but keeps track of the notes so that no note repeats until all of the others have played. Walk is a “random walk” order: each successive note is e…

223, Master Mode The Soft Buttons in Master Mode (Page 1 and Page 2) 11-9 Utils Pressing the Utils soft button calls up the Utility page, which gives you access to two analytic and diagnostic tool. Additionally, pressing the two right-most soft buttons will call up the Utility page from…

155, Setup Mode The SWITCH Page 7-35 The SWITCH Page The right Panel switch is the SW button, located above the Modwheel. By default, this switch is assigned to MIDI29, but you can assign this switch to any MIDI Controller. The SWITCH page parameters are described in Switch Controllers on page 7-21. Pa…