Kustom KHS6440 Owner's Manual

9, Page 1 KHS6440 Installation Manual Recommended Cables: Category-5 or Category-3 (4 twisted pair stranded), shielded or unshielded. 16-4 or (2) 16-2 speaker cables. To keep the installation process as simple as possible for first time users, please follow these simple steps. These instructions ar…

12, KHS6D CONTROLLER 8.) Reset - This resets the local zone controller if an IR command locks up the zone. It will not erase the local zone memory. It will just send a local clear command. 9.) Clear - This button has 3 modes: a.) Device mode - Will clear learned commands from the local z…

20, SPECIFICATIONS Power Output: 20 Watts at 6 ohms x 12 Frequency Response: 20 Hz-20 kHz (+/- 1 dB) T.H.D.: 0.2% or less @ rated power Signal/Noise Ratio: >80 dB (A weighted) Slew Rate: 10V/u sec. Input Impedance: 10k Ohms Input Sensitivity: -10 dBv for rated output Dimensions: 17&quo…

5, Kustom KHS6440 CONTROLLER SECTION 7.) Master Output - This connector allows the party mode to apply to multiple units if additional units are added. 8.) Master Input - This is for the party mode controller. This controller should be located near the unit and sources. It will override all zone c…

3, A.) Power Switch - Left on, the KHS6440, when not being used, will go into a sleep mode, ready to turn back on when an input signal is applied from any of the six sources. In the off position, the unit will not function. B.) On LED - With the power switch on, this LED indicates th…

16, Page 8 1) Remove the Decora cover plate, and controller face plate. 2) Place your wireless remote in learn mode. 3) Select the device bank button to program (i.e. TV, VCR, Tuner, Aux, etc.) on the wireless remote. 4) Select the button to be programmed on the learning remote. (i.e. 1-6, mute, o…