Lantronix WiBox2100E Operation & User’s Manual

48, Setup Mode: Server Configuration WiBox2100E User Guide 48 DHCP Name If a DHCP server has automatically assigned the IP address and network settings, you can discover the unit by using the DeviceInstaller network search feature or Monitor Mode (see 9: Monitor Mode). Note: When you ente…

19, WiBox2100E User Guide 19 3 3 : : G G e e t t t t i i n n g g S S t t a a r r t t e e d d This chapter describes the procedures for getting your WiBox units up and running. Installing the WiBox Note: For diagrams of the mounting bracke…

75, WiBox2100E User Guide 75 9 9 : : M M o o n n i i t t o o r r M M o o d d e e Monitor Mode is a command-line interface used for diagnostic purposes. There are two ways to enter Monitor Mode: locally via the serial port or remotely via the network. Enter…

37, Lantronix WiBox2100E Web-Manager Configuration WiBox2100E User Guide 37 Common Options Telnet Com Port Cntrl Available for configuration only when Active Connect is set to None. Select Enable to permit Telnet communication to the WiBox unit. The Telnet Com Port Cntrl feature is used in conjunction with …

47, Setup Mode: Server Configuration WiBox2100E User Guide 47 For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; only DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.) This is the most common setting when using DHCP…